Introduction of batch type LC filling equipment
It is a batch type LC filling equipment.
We propose various suggestions depending on the panel size and amount of throughput.
It corresponds to heating and weighting as an option.
It is a type of LC filling equipment that connects the panel to LC in vacuum condition.
Introduction of LC filling equipment as LC-D type (mass production for small size LCD)
It is LC filling equipment as a dispenser-type.
By using our original dispenser for vacuum condition, the amount of LC is 1/3 or less of that of the conventional.
The dripping sensor enables reliable filling.
It is possible to install a degassing chamber, a heating mechanism, and a high vacuum system.
Introduction of LC filling equipment as LC-DS type
It is LC filling equipment as a dispenser-type .
It is LC filling equipment as a dispenser-type .
It fills the LC from top and bottom side.
The upper part is filled by a dispenser and the lower part is filled by a boat at the same time.
The filling time can be reduced to 1/3 of conventional.
|
Substrate size (inch) |
Conventional method (min) |
LC-DS type(min) |
| 17 | 360 | 110 |
| 17 | 180 | 52 |
| 15 | 120 | 45 |
| 10 | 118 | 38 |
| 6 | 210 | 75 |
Comparison table of filling time
Introduction of LC filling equipment as ILC-1000L type
It is an in line type LC filling equipment.
It corresponds from small or medium size to large size panels.
It has a vacuum annealing function by our original heating method.
It can easily corresponds to high-mix low-volume production. (Setup change)
LC automatic supply, pressurized filling, and CIM correspondence are possible.
It consists of a vacuum exhaust chamber, a heating exhaust chamber, an filling chamber, an atmospheric pressure heating chamber and a weighting heating chamber.
It is a mass-production equipment that stably produces high quality LCD by in line filling between high vacuum (10E-7 Torr) and 0.5 MPa pressure range.